Guide for fitting Rugged Tools Dewalt Anti Wobble Inserts for Dewalt Toughsystem 2.0 Drawers.
Installation Instructions
- Locate the four key-shaped sections on the top edges of the drawer toolbox - two towards the front and two towards the back.
- Take the two inserts marked "FRONT" and align there key shaped holes at the front of the drawer box (note these are slighly longer than the backs)
- Using a hammer, carefully tap each front insert into the holes until they are seated flush. The inserts should fit very snugly into the key-shaped holes
- Repeat step 3 with the two inserts marked "BACK", tapping them into the pre-drilled holes in the back key-shaped sections.
- Once all four inserts are installed, its time to test, fit your toolbox into the tough system 2.0 clips and make sure everything is dandy!
- The anti-wobble inserts nested in the key-shaped sections will keep your drawer firmly in place, preventing front-to-back wobble when opening and closing the draws
Notes:
- Only use Rugged Tools anti-wobble inserts with genuine DeWalt ToughSystem 2.0 toolboxes.
- make sure the key shaped holes are free from dust and debris before installing
For any additional questions or support, please contact us via email or whatsapp.