Rugged Tools Apple AirTag Mount for Milwaukee Packout Drawer Toolboxes

Rugged Tools Apple AirTag Mount for Milwaukee Packout Drawer Toolboxes

Rugged Tools Apple AirTag Mount for Milwaukee Packout Drawer Toolboxes

Package Contents:

  • 1x Rugged Tools Apple AirTag Mount
  • 2x 6mm black self-tapping screws
  • 1x PH1 1/4" screwdriver bit

 

 

Installation Instructions:

  1. Carefully unpack the mount and screws. CAUTION: The screws are very small and easy to lose. Handle with care.
  2. Insert your Apple AirTag into the cutout section of the mount. You will hear a click when the AirTag is properly seated.
  3. Locate the appropriate moulding on the underside of your Milwaukee Packout drawer toolbox.
  4. Position the mount with the AirTag facing the toolbox, aligning it with the cut out moulding.
  5. Using a screwdriver with the provided PH1 1/4" bit, insert the two 6mm black self-tapping screws into the recessed holes at the edges of the mount. Drive the screws at a 45-degree angle.

 

IMPORTANT: Do NOT use an impact driver or over-tighten the screws. Doing so may strip the threads created in the toolbox by these small screws.

Back to blog