Rugged Tools - Dewalt Toughsystem Baseplates Box locator Mounts.

Rugged Tools - Dewalt Toughsystem Baseplates Box locator Mounts.

Rugged Tools Locating Baseplates

For DeWalt ToughSystem Toolbox & Tote Range

Product Overview

A set of 2 heavy-duty base plates designed to securely anchor your DeWalt ToughSystem 2.0 toolbox or Toughsystem tote to the floor. Each plate is marked with 'FRONT' to ensure proper orientation.

What's Included

  • 2x Rugged tools Floor locating plates

Required Materials (Not Included)

  • Appropriate screws for your floor type:
    • For concrete floors: Concrete anchors/screws
    • For wooden floors: Wood screws
    • For metal surfaces: Self-tapping screws

Required Tools

  • Screwdriver or drill with a low torque setting
  • Measuring tape
  • Pencil for marking
  • Appropriate drill bit if pre-drilling holes

Critical Measurements

  • Width: 395mm between inside edges of the base plates

Installation Steps

1. Preparation

  • Clean the installation area thoroughly
  • Ensure you have appropriate screws for your mounting surface
  • Gather all required tools

2. Plate Identification

  • Locate the 'FRONT' marking on each base plate
  • Determine which direction you want your toolbox to face

3. Initial Positioning

  • Place both plates with their 'FRONT' markings facing the direction you want the front of the toolbox to face
  • Ensure both plates are roughly parallel to each other

4. Measuring and Marking

  • Measure exactly 395mm between the inside edges of the plates
  • Take this measurement at both the top and bottom of the plates to ensure parallel alignment
  • Mark the position of all screw holes
  • If required for your floor type, pre-drill the holes

5. Securing the Plates

  • Begin installing screws through the countersunk holes
  • Start with partially tightening screws to allow for final adjustments
  • IMPORTANT: Do not over-tighten the screws
  • Double-check your 395mm measurement before final tightening

6. Final Alignment Check

  • Verify the plates are straight and properly aligned
  • Confirm the 395mm spacing is consistent
  • Ensure all screws are secure but not over-tightened
  • Check that both 'FRONT' markings are facing the correct direction

7. System Ready

  • Your base plates are now ready for use
  • Simply drop your ToughSystem toolbox or tote into place

Compatibility

  • Works with ALL DeWalt ToughSystem 2.0 Toolbox range (full size)
  • Compatible with DeWalt ToughSystem Tote range

Usage Tips

  • When removing the toolbox, lift straight up to avoid catching on the plates
  • Keep the mounting area clean for optimal performance
  • Periodically check that screws remain tight

Troubleshooting

  • If toolbox doesn't fit properly:
    • Verify both 'FRONT' markings are facing the correct direction
    • Recheck the 395mm measurement between plates
    • Ensure plates are parallel to each other
  • If plates feel loose: Check and tighten screws as needed
  • If toolbox feels tight: Verify plates haven't shifted from original measurements

Contact Support

Whatsapp: +44 (0)1491 313 156

Email: hello@ruggedtools.co.uk

Warranty Information

Limited Lifttime against manufactures defect

Back to blog